Wireless Bluetooth RS232 TTL Transceiver Module 4 pins HC-06 Pi Arduino
Wireless Bluetooth RS232 TTL Transceiver Module 4 Pins Raspberry Pi Arduino NEW
This is the EGBT-046S Bluetooth Modem module that we use in our HT Bluetooth Module.
These modems work as a serial (RX/TX) connection, and are a great wireless replacement for serial cables. Any serial stream from 1200 to 115200bps can be passed seamlessly from your computer to your target. The module has a pin spacing of 1.5mm. This is a 3.3V device and should not be connected to 5V systems without level conversion.
The EGBT-046S Bluetooth Module is a generic Bluetooth device loaded with SPP firmware for UART wireless cable replacement functions. EGBT-046S is permanently programmed as a Bluetooth slave device.
You can use it straight out of the box as a UART wireless cable replacement, without any need to add set-up codes in your microcontroller application.
Radio Chip: CSR BC417
Memory: External 8Mbit Flash
Output Power: -4 to +6dbm Class 2
Range: Up to around 30 feet (10 m)
Sensitivity: -80dbm Typical
Bit Rate: EDR, up to 3Mbps
Voltage: 3.3V DC
The default configuration is:
Baud Rate: 9600 bps
Data : 8 bits
Stop Bits: 1 bit
Parity : None
Device Name: linvor
Bluetooth Module Dimensions
Pin Spacing 1.5mm
1 x Wireless Serial 4 Pin Bluetooth RF Transceiver
Product ID: EP065